ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2-20. PANEL LIGHTS.
2-20.1 Inspection.
Inspect panel light holder and directional cap for cracks, corrosion, stripped threads, and other damage
2–20.2
a.
b.
c.
d.
e.
f.
2-20.3
a.
b.
2-20.4
a.
b.
2-20.5
a.
b.
c.
d.
e.
Removal.
Shut down generator set.
Open battery access door and disconnect negative battery cable.
Release control panel by turning two fasteners and lower control panel slowly.
Tag and disconnect panel light (1, FIGURE 2-11) electrical leads.
Remove nut (2) and washer (3).
Remove panel light (1) from control panel.
Disassembly.
Remove panel light directional cap (4, FIGURE 2-11)
Remove panel light bulb (5).
Assembly.
from panel light housing (1).
Install panel light bulb (5, FIGURE 2-11) into panel light housing (l).
Install panel light directional cap (4).
Installation.
Insert panel light (1, FIGURE 2-11) into control panel.
Install washer (3) and nut (2).
Connect panel light electrical leads and remove tags.
Raise and secure control panel.
Connect negative battery cable. Close battery access door.
2-21 PRESS TO LIGHTS.
2-21.1
a.
b.
2-21 .2
a.
b.
c.
d.
e.
f.
g.
Inspection.
Inspect lights for cracks, corrosion, evidence of shorting, and other damage.
Replace or repair lights as necessary.
Testing.
Place MASTER SWITCH in either PRIME& RUN position.
Press in lamp holders (6, FIGURE 2-11) and check that lamps are lit.
If lamp (7) fails to light perform steps d through g.
Release control panel by turning two fasteners and lower control panel slowly.
Set multimeter for DC volts and check for voltage at terminals 1 and 3 on light receptacle (10).
If voltage is present, replace press to test light assembly.
Raise and secure control panel.
2-49
