ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARINE CORPS TM 09244A/09245A-24/2
2-70 CONTROL BOX BOTTOM.
2-70.1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
2-70.2
a.
b.
2-70.3
a.
b.
c.
d.
2–70.4
a.
b.
c.
d.
e.
f.
g.
h.
i.
Removal.
Shut down generator set.
Open battery access door and disconnect negative battery cable.
Remove control box assembly, paragraph 2-19.2.
Remove control panel frame, paragraph 2-68.1.
Remove control box side panels, paragraph 2-69.1.
Remove control box components, paragraphs 2-42 through 2-50, 2-52 through 2-61, 2-65, and 2-66.
Contact Direct Support Maintenance to remove AC voltage regulator and control box harness.
Remove screws (34, FIGURE 2-19) and bracket (35) from control box bottom (42).
Remove screws (36), nuts (37), and relay tracks (38) from control box bottom (42).
Remove screws (39), nuts (40), and latch plate (41) from control box bottom (42).
Inspection.
Inspect control box bottom (42, FIGURE 2–19) for dents, cracks, loose paint, and corrosion.
Inspect for missing or damaged cage nuts (43).
Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
Replace missing or damaged cage nuts.
Installation.
Install latch plate (41, FIGURE 2-19) on control box bottom (42) with screws (39) and nuts (40).
Install relay tracks (38) on control box bottom (42) with screws (36) and nuts (37).
Install bracket (35) on control box bottom (42) with screws (34).
Contact Direct Support Maintenance to install control box harness and AC voltage regulator.
Install control box components, paragraphs 2-42 through 2-50, 2–52 through 2-61,2-65, and 2-66.
Install control box side panels, paragraph 2-69.4.
Install control panel frame, paragraph 2-68.4.
Install control box assembly, paragraph 2-19.4.
Connect negative battery cable and close battery access door.
2-101
