ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
l.
Remove output box harness, paragraph 4-10-2,
m. Remove nuts (38), screws (39), and AC circuit interrupter relay (40).
n.
Remove nuts (41), screws (42), and cranking relay (43).
o.
Remove nuts (6, FIGURE 4-4), bolts (7), and output box panels from generator set.
P.
Remove bolts (45), nuts (44), and output box side panels (46) and (47) from output box bottom panel (51).
q.
Remove grommets (48), (49), and (50) from output box panels (3) and (51).
r.
If necessary, remove door seal (52) and EMI seal (53) from output box top panel (3).
4-14-3 Repair.
WARNING
Wear protective mask and gloves when sanding CARC painted surfaces. CARC paint
dust is a health hazard and could cause personal injury if warning is not followed.
a. Repair all dents and cracks, and remove all loose paint.
b. Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
c.
Replace damaged seals and grommets.
d. Repaint surfaces in accordance with TM 43-0139. (F) Refer to applicable directives.
4-14-4 Installation.
a.
Install grommets (48, 49, and 50, FIGURE 4-5) in output box panels (3) and (51).
b. Install output box side panels (46) and (47) on output box bottom panel (51) with bolts (45) and nuts (44).
c.
Install output box panels in generator set with bolts (7) and nuts (6).
d. Install cranking relay (43) with screws (42) and nuts (41).
e.
Install AC circuit interrupter relay (40) with screws (39) and nuts (38).
f.
Install current transformer, paragraph 4-11-3.
g.
Install power potential transformer, paragraph 4-13-4.
h. Install droop current transformer, paragraph 4-12-3.
i.
Install voltage reconnection terminal board, paragraph 4-9-2.
j.
Install output box harness, paragraph 4-10-5.
k.
Install air cleaner assembly, paragraph 2-73-4.
l.
Install output box top panel (3) with bolts (2) and nuts (1).
m. If removed, install self-adhesive door seal (52), and EMI seal (53) with adhesive (Item 1, Appendix C) on output
box top panel (3).
4-26
