ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
n.
o.
r.
s.
t.
Remove clip halves (23) and insulation (24) from baffle (22).
Remove bolts (25), assembled nuts (26), and fuel filler neck panel (27) from left side rear panel (19).
N O TE
Ensure output box assembly is secured prior to removal of corner post
and door sills.
Remove bolts (28), (32), and (34); flatwashers (29); Iockwashers (30); nuts (31); assembled nuts (33) and (35);
corner post (36); and door sills (37) and (38) from generator set.
Remove bolts (39), (43), (47), and (49); flatwashers (40) and (44); Iockwashers (41) and (45); nuts (42) and (46);
assembled nuts (48) and (50); and right side panel (51 ) from generator set.
If necessary, drill out rivets (52) and remove plate (53) from left side rear panel (19).
If necessary, drill out rivets (54) and remove plate (55) from fuel filler neck panel (27).
If necessary, remove output box EMI seals (56) from door sill (37), corner post (36), and right side panel (51).
2.18.2. Inspection.
a. Shut down generator set.
b. Inspect rear housing section panels for dents, cracks, loose paint, corrosion, and other damage.
c. Inspect all cage nuts (57, FIGURE 2-9) for cracking or stripped threads.
d. Inspect all insulation for damage and missing clip halves.
e. Inspect EMI seals (56) for tears, looseness, and deterioration.
f. Inspect door seals (58) for tears, looseness, and deterioration.
2.18.3. Repair .
a.
b.
c.
d.
e.
f.
g.
Wear a protective mask and gloves when sanding CARC painted sur-
faces. CARC paint dust is a health hazard and could cause personal
injury if warning is not followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Use applicable directives.
Replace all cracked or stripped cage nuts (57, FIGURE 2-9).
Replace damaged insulation and missing clip halves (23). Refer to Appendix D for fabrication of insulation.
Replace EMI seals (56) that are loose or show any evidence of damage.
Replace damaged door seals (58).
2-45
