ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
i.
i.
k.
l.
Remove bolts (22) and (24), assembled nuts (23) and (25), and panel (26).
Remove bolts (27) and (31), flatwashers (30), Iockwashers (29), nuts (28), assembled nuts (32), and top side panels
(33) and (34) with top section floor panel (35).
Remove bolts (36), assembled nuts (37), and panel (38) from floor panel (35).
Remove bolts (39), assembled nuts (40), and support (41) from panel (38).
m. Remove bolts (42), assembled nuts (43), and side panels (34) and (33) from floor panel (35)
n. Remove bolt (44), assembled nut (45), and bracket (46) from angle (49).
N O T E
Open output box access door to reach assembled nuts (48).
o. Remove bolts (47), assembled nuts (48), and angle (49) from generator set.
2.16.2. Inspection.
a.
b.
c.
d.
Shut down generator set.
Inspect all top housing section panels for dents, cracks, loose paint, and corrosion.
Inspect all cage nuts (50, FIGURE 2-7) for cracking or stripped threads.
Inspect seal (51) for tears, looseness, and deterioration.
2.16.3.
Repair.
Wear a protective mask and gloves when sanding CARC painted sur-
faces. CARC paint dust is a health hazard and could cause personal
injury if warning is not followed.
a. Repair all dents and cracks, and remove all loose paint.
b. Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
c. Repaint surfaces in accordance with TM 43-0139. (F) Refer to applicable directives.
d. Replace any cage nuts (50, FIGURE 2-7) that are stripped or cracked.
e. Replace loose or damaged seal (51).
2.16.4.
Installation.
a. Install angle (49, FIGURE 2–7) in generator set with bolts (47) and assembled nuts (48).
b. Install bracket (46) to angle (49) with bolt (44) and assembled nut (45).
c. Install top side panels (34) and (33) on top section floor panel (35) with bolts (42) and assembled nuts (43).
d. Install support (41) on panel (38) with bolts (39) and assembled nuts (40).
e. Install panel (38) on top section floor panel (35) with bolts (36) and assembled nuts (37).
f. Position top section floor panel (35), with side and front panels attached, in generator set and secure with bolts (27)
and (31), flatwashers (30), Iockwashers (29), nuts (28), and assembled nuts (32).
g. Install panel (26) with bolts (22) and (24), and assembled nuts (23) and (25).
h. Install air duct channels (20) and (21) with bolts (18), and assembled nuts (19).
2-40
