ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
i.
i.
k.
l.
m.
n.
2.17.
Install muffler, paragraph 2.70.3.
Install frame (17) with bolts (14), flatwashers (16), and Iockwashers (15).
Install radiator fill panel (13) in generator set and connect radiator fill hose and overflow hose to panel (13).
Install top housing panel (6) with bolts (7) and (10), flatwashers (9) and (12), and Iockwashers (8) and (11).
Install mount (4) and exhaust cover (5) with bolts (1), flatwashers (3), and Iockwashers (2).
Install control box assembly, paragraph 2.19.4.
FRONT HOUSING SECTION.
2.17.1. Removal.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
0.
p.
q.
r.
Shut down generator set.
Remove battery box access door, paragraph 2.14.1.
Remove engine access doors, paragraph 2.14.1.
Remove top housing section, paragraph 2.16.1.
Remove batteries, paragraph 2.12.2 and slave receptacle, paragraph 2.13.2.
Remove bolts (1, FIGURE 2–8) and ground rods (2) from brackets (54).
Remove bolts (3), (6), and (10); flatwashers (5), (7), and (11); Iockwashers (4), (8), and (12); nuts (9) and (13); and
front panel (14) from generator set.
Remove bolts (15) and (18), flatwashers (17) and (19), Iockwashers(16) and (20), nuts (21 ), and side panels (22)
and (23) from generator set.
Remove clip halves (24) and insulation (25) from front panel (14).
Remove bolts (26) and (29), washers (28), Iockwashers (27), assembled nuts (30), and air deflector (31) from front
paneI (14).
Remove bolts (32), Iockwashers (33), washers (34), and panels (35) and (36) from front panel (14).
Remove bolts (37), assembled nuts (38), and supports (39) and (40) from panels (35) and (36).
Remove bolts (41) and panel (42) from front panel (14).
Remove bolts (43), assembled nuts (44), and support (45) from panel (42).
Remove bolts (46), assembled nuts (47), and support channel (48) from front panel (14).
Remove bolts (49), assembled nuts (50), and slave receptacle box (51 ) from side panel (22).
Remove bolts (52), assembled nuts (53), and brackets (54) from panels (14) and (22).
If necessary, drill out rivets (55), (56), and (57); remove identification plates (58), (59), and (60).
2.17.2.
Inspection.
a. Shut down generator set.
b. Inspect all front housing section panels for dents, cracks, loose paint, corrosion, and other damage.
c. Inspect all cage nuts (61, FIGURE 2–8) for cracking or stripped threads.
d. Inspect insulation for damage and missing clip halves (24).
e. Inspect seals (62) and (63) for tears, looseness, and deterioration.
2-41
