ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
2.17.3. Repair.
a.
b.
c.
d.
e.
f.
Wear a protective mask and gloves when sanding CARC painted sur-
faces. CARC paint dust is a health hazard and could cause personal
injury if warning is not followed.
Repair all dents and cracks, and remove ail loose paint.
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
Repaint surfaces in accordance with TM 43-0139. (F) Refer to applicable directives.
Replace any cracked or stripped cage nuts (61, FIGURE 2-8).
Replace damaged insulation and missing clip halves (24). Refer to Appendix D for fabrication of insulation.
Replace loose or damaged seals (62) and (63).
2.17.4.
Installation.
a.
b.
c.
d.
e.
If removed, install identification plates (58, 59, and 60, FIGURE 2–8) on front panel (14) and side panel (22) with
rivets (55), (56), and (57).
Install brackets (54) on panels(14) and (22) with bolts (52) and assembled nuts (53).
Install slave receptacle box (51) on side panel (22) with bolts (49) and assembled nuts (50).
Install side panels (22) and (23) on generator set with bolts(15) and (18), flatwashers (17) and (19), Iockwashers
(16) and (20), and nuts (21).
Install support channel (48) on front panel (14) with bolts (46) and assembled nuts (47).
2-42
