ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
2.18.4. Installation.
a. If removed, install plate (55, FIGURE 2–9) on fuel filler neck panel (27) with rivets (54).
b. If removed, install plate (53) on left side rear panel (19) with rivets (52).
c. Install right side panel (51) on generator set with bolts (39), (43), (47), and (49); flat washers (40) and (44); lock-
washers (41) and (45); nuts (42) and (46); and assembled nuts (48) and (50).
d. Install door sills (37) and (38), and corner post (36) on generator set with bolts (28), (32), and (34); flatwashers (29);
Iockwashers (30); nuts (31); and assembled nuts (33) and (35).
e. Install fuel filler neck panel (27) on left side rear panel (19) with bolts (25) and assembled nuts (26).
f. Install insulation (24) on baffle (22) with clip halves (23).
g. Install baffle (22) on left side rear panel (19) with bolts (20) and assembled nuts (21).
h. Install left side rear panel (19) on generator set with bolts (12) and (16), flatwashers (13) and (18), Iockwashers
(14) and (17), and nuts (15).
i. Install load entrance box (11) on rear panel (8) with bolts (9) and assembled nuts (10).
j. Install rear panel (8) on generator set with bolts (1) and (4), flatwashers (3) and (5), Iockwashers (2) and (6), and
nuts (7).
k. If removed, install output box EMI seals (56) on door sill (37), corner post (36), and right side paneI (51) with adhe-
sive (Item 1, Appendix C). Ensure closed side of seal faces outward.
l. Install top housing panel, paragraph 2.16.4, step 1.
m. Install fuel float module, paragraph 2.92.4,
n. Install auxiliary fuel pump, paragraph 2.86.4.
o. Install fuel filler neck, paragraph 2.87.3.
p. Install air cleaner access door and engine access doors, paragraph 2.14.4.
q. Install load terminal board access door and output box access door, paragraph 2.14.4.
N O TE
Output box EMI seals are primary suppression components. Ensure
that a complete seal is made between output box door and generator
set.
r. Install air cleaner assembly, paragraph 2.72.4.
s. Install control box assembly, paragraph 2.19.4.
Section X. MAINTENANCE OF CONTROL BOX ASSEMBLY
2.19. CONTROL BOX ASSEMBLY.
2.19.1 Inspection.
a. Shut down generator set.
b. Inspect control box assembly for cracks, breaks, corrosion, loose paint, and missing parts.
2-47
