ARMY TM 9-6115-643-10
AIR FORCE TO 35C2-3-445-21
Stopping Procedure.
2-10.2 Pre-Operation.
Place AC CIRCUIT
a.
WARNING
INTERRUPTER switch in
OPEN position.
Prior to making
any connections
b.
Allow generator set
for parallel
to operate five
operation, ensure
minutes with no load
that there is no
applied.
input to the load
and that the
c.
Place MASTER SWITCH
generator sets are
in OFF position.
shut down.
Failure to observe
d.
Perform all AFTER (A)
this warning can
OPERATION PMCS
result in injury
requirements in
or death by
accordance with TABLE
electrocution.
2-3.
Ensure that load
a.
Place DEAD CRANK
e.
requirement is equal
switch in OFF
or below the
position.
combined rated
capacity of the two
PARALLEL UNIT OPERATION
generator sets.
(LOAD SHARING).
CAUTION
Ensure generator
Never attempt to
sets are the same
start the
size and mode
generator set if
before attempting
it is not
parallel
properly
operation.
grounded.
Failure to
2-10.1 General. The following
observe this
method of Parallel operation
warning could
will be used to share the load
result in
between two generator sets.
Refer to FIGURE 2-1 for location
serious injury
or death by
of operator controls and
electrocution.
indicators mentioned below and
FIGURE 2-5 for proper
paralleling configuration.
