ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
l.
m.
n.
o.
p.
q.
r.
s.
t.
u.
v.
2-19.5
a.
b.
c.
d
2-19.6
a.
b.
c.
d.
Install front lifting rings (31) and brackets (30) on generator set with bolts (26), Iockwashers (28), washers (29),
and nuts (27).
Install fuel tank filler neck, paragraph 281 .3.
Route electrical leads through air deflector (55) and connect leads, as tagged to fuel level sender and fuel float
module. Remove tags.
Install auxiliary fuel pump, paragraph 2-84,4.
Install fuel transfer pump, paragraph 2-85.4.
Connect fuel supply and fuel return lines at fuel tank fittings (16 and 32, FIGURE 2-21).
Install radiator, paragraph 270.5.
Install front housing panel, paragraph 2-18.4.
Install deflectors (23), (24), and (25) with bolts (21 ) and nuts (22). Install bolts (1 8), Iockwashers (19), and wash-
ers (20).
Install top housing panel, paragraph 2-17.4.
Connect negative battery cable and close access door.
Removal
of
Enigne
Access
Door
Sills.
Remove bolt (65, FIGURE 2-8), nut (66), Iockwasher (67), washer (68), front grounding rod bracket (69), and
grounding rods (70) from generator set.
Remove bolts (9, FIGURE 2-23), washers (10), Iockwashers (11 ), nuts (1 2), and plate(13) from left side engine
access door sill (77, FIGURE 2-8).
Remove bolts (71), nuts (72), Iockwashers (73), and washers (74).
Remove bolts (75), nuts (76), and engine access door sills (77) and (78).
Installation of Engine Access Door Sills.
Install bolts (75, FIGURE 2-8), nuts (76), and engine access door sills (77) and (78).
Install bolts (71), nuts (72), Iockwashers (73), and washers (74) securing door sills (77) and (78).
Install bolt (65), nut (66), Iockwasher (67), washer (68), front housing grounding rod bracket (69), and grounding
rods (70) on generator set.
Install botts (9, FIGURE 2-23), washers (10), Iockwashers (11), nuts (12), and plate (13) to left side door sill
(77, FIGURE 2-8).
2-20
R E A R H O U S I N G S E C T I O N .
2-20.1 Removal.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Remove control box assembly, paragraph 2-21.2.
d. Remove load terminal and storage box access doors, paragraph 2-15.2.
e.
Remove top housing panel, paragraph 2-17.1.
f.
Remove engine access doors, paragraph 2-15.2.
9.
Remove DEAD CRANK switch, paragraph 2-96.2.
h. Remove oil pressure sender, paragraph 2-91.2 and oil line (3, FIGURE 225) at engine fitting (24).
i.
Remove low oil pressure switch, paragraph 2-90.2.
2-43
