ARMY TM 9-6115-642-24AIR FORCE TO 35C2-3-455-12MARINE CORPS TM 09247A/09248A-24/2j.Remove NATO SLAVE RECEPTACLE, paragraph 2-13.2.k.Remove frequency adjust control cable assembly, paragraph 2-89.1.l.Remove air cleaner assembly, paragraph 2-67.1.m. Remove load terminal board upper mounting bracket, paragraphnRemove bolts (1, FIGURE 2-9), nuts (2), and upper door sill (3).o.Remove bolts (4), nuts (5), and center door post (6).p.Remove bolts (7), nuts (8), lockwashers (9), washers (10), and lower door sill (11)q.Remove bolts (12), nuts (13) lockwashers (14) washers (15), rear lifting rings brackets (16), and liftingrings (17).r .Remove bolts (18) and nuts (19), four places each side.s.Remove bolts (20), lockwashers (21), washers (22), and rear side panels (23) and (24).t.Remove bolts (25), nuts (26), and slave receptacle box (27) from side panel (24).u.Remove bolts (28), lockwashers (29), washers (30), and deflector (31) from side panel (24).v.Remove bolts (32), nuts (33), lockwashers (34), washers (35), and stiffener (36) from side panel (24).w . Remove bolts (37), nuts (38), and load entrance box assembly (39) from side panel (23).x.Remove bolts (40), nuts (41), and frequency control cable box (42) from side panel (23).y.Remove nut (74), bolt (72). washer (73), power cable clamp (75) from deflector (46).z.Remove bolts (43), lockwashers (44), washers (45), and deflector (46) from side panel (23)aa. Remove bolts (47) nuts (48), lockwashers (49), washers (50), and stiffener (51) from side panel (23)ab. Remove bolts (52) and (56), nuts (55) and (57), washer (53), and spacer (54) securing output boxassembly to center housing panel (62). Carefully lay output box assembly on generator.ac. Remove nuts (58) lockwashers (59) washers (60) bolts (61), and center housing panel (62) fromgenerator set.ad. If necessary, remove nuts (63) and bolts (64) and disassemble gasket (65), ring (66), and sleeve (67)from load entrance box (39).ae. If necessary, remove clip halves (68) and sound insulation (69) from deflectors (46) and (31).2-20.2. Inspection.aShut down generator set.b.Inspect all rear housing parts for dents, cracks, loose paint, and corrosionc.Inspect for missing or damaged cage nuts (70, FIGURE 2-9).d.Inspect door seals (71) for looseness and damage.e.Inspect sound insulation (69) for damage and missing clip halves (68)2-20.3. Repair.Wear a protective mask and gloves when sanding CARC painted surfaces. CARC paintdust is a health hazard and could cause personal injury if warning is not followed.a.Repair all dents and cracks, and remove all loose paint.b.Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).c.Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.d.Replace all missing or damaged cage nuts (70)Change 4 2-45
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
