ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-20-1 Removal - Continued.
aa.
ab.
ac.
2-20-2.
a.
b.
c.
d.
2-20-3.
a.
b.
c.
d.
e.
2-20-4.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
2-46
Remove bolts (52) and (56), nuts (55) and (57), washer (53), and spacer (54) securing output box assembly
to center housing panel (62). Carefully lay output box assembly on generator.
Remove nuts (58), Iockwashers (59), washers (60), bolts (61), and center housing panel (62) from generator
set.
If necessary, remove nuts (63) and bolts (64) and disassemble gasket (65), ring (66), and sleeve (67) from load
entrance box (39).
Inspection.
Shut down generator set.
Inspect all rear housing parts for dents, cracks, loose paint, and corrosion.
Inspect for missing or damaged cage nuts (68, Figure 2-9).
Inspect door seals (69) for looseness and damage.
Repair.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
Repaint surface in accordance with TM 43–0139. (F) Refer to applicable directives.
Replace all missing or damaged cage nuts (68).
Replace damaged door seals (69).
Install center housing panel (62, Figure 2-9) on generator set with bolts (61), washers (60), Iockwashers (59),
and nuts (58).
Secure output box assembly to center housing panel (62) with bolts (52) and (56), nuts (55) and (57), washer
(53), and spacer (54).
Install stiffener (51) on side panel (23) with bolts (47), washers (50), Iockwashers (49), and nuts (48).
Install deflector (46) on side panel (23) with bolts (43), Iockwashers (44), and washers (45).
Install frequency control cable box (42) on side panel (23) with bolts (40) and nuts (41).
If removed, install sleeve (67), ring (66), gasket (65), nuts (63), and bolts (64) to load entrance box (39).
Install load entrance box assembly (39) on side panel (23) with bolts (37) and nuts (38).
Install stiffener (36) on side panel (24) with bolts (32), washers (35), Iockwashers (34), and nuts (33).
Install deflector (31) on side panel (24) with bolts (28), Iockwashers (29), and washers (30).
Install slave receptacle box (27) on side panel (24) with bolts (25) and nuts (26).
Install rear side panels (23) and (24) on generator set with bolts (20), Iockwashers (21), and washers (22).
Install bolts (18) and nuts (19), to secure rear side panels (23) and (24) to center housing panel (62).
Install rear lifting ring brackets (16) and lifting rings (17) on skid with bolts (12), washers (15), Iockwashers (14),
and nuts (13).
Installation.
