ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-19-6. Installation of Engine Access Door Sills.
a.
Install bolts (80, Figure 2-8), nuts (81), and engine access door sills (82) and (83).
b.
Install bolts (76), nuts (77), Iockwashers (78), and washers (79) securing door sills (82) and (83).
c.
Install bolt (70), nut (71), Iockwasher (72), washer (73), front housing grounding rod bracket (74), and grounding
rods (75) on generator set.
d. Install bolts (9, Figure 2-23), washers (10), Iockwashers (11), nuts (12), and plate (13) to left side door sill (82,
Figure 2-8).
2-20. REAR HOUSING SECTION.
2-20-1. Removal.
a. Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Remove control box assembly, paragraph 2-21-2.
d.
Remove load terminal and storage box access doors, paragraph 2-15-2.
e.
Remove top housing panel, paragraph 2-17-1.
f.
Remove engine access doors, paragraph 2-15-2.
g.
Remove DEAD CRANK switch, paragraph 2-96-2.
h. Remove oil pressure sender, paragraph 2-91-2 and oil line (3, Figure 2-25) at engine fitting (24).
i.
Remove low oil pressure switch, paragraph 2-90-2.
j .
Remove NATO SLAVE RECEPTACLE, paragraph 2-13-2.
k.
Remove frequency adjust control cable assembly, paragraph 2-89-1.
l.
Remove air cleaner assembly, paragraph 2-67-1.
m. Remove load terminal board upper mounting bracket, paragraph 2-97-1.
n. Remove bolts (1, Figure 2-9), nuts (2), and upper door sill (3).
o.
Remove bolts (4), nuts (5), and center door post (6).
p.
Remove bolts (7), nuts (8), Iockwashers (9), washers (10), and lower door sill (11).
q.
Remove bolts (12), nuts (13), Iockwashers (14), washers (15), rear lifting rings brackets (16), and lifting rings
(17).
r.
Remove bolts (18) and nuts (19), four places each side.
s.
Remove bolts (20), Iockwashers (21), washers (22), and rear side panels (23) and (24).
t.
Remove bolts (25), nuts (26), and slave receptacle box (27) from side panel (24).
u.
Remove bolts (28), Iockwashers (29), washers (30), and deflector (31) from side panel (24).
v.
Remove bolts (32), nuts (33), Iockwashers (34), washers (35), and stiffener (36) from side panel (24).
w.
Remove bolts (37), nuts (38), and load entrance box assembly (39) from side panel (23).
x.
Remove bolts (40), nuts (41), and frequency control cable box (42) from side panel (23).
y.
Remove bolts (43), Iockwashers (44), washers (45), and deflector (46) from side panel (23).
z.
Remove bolts (47), nuts (48), Iockwashers (49), washers (50), and stiffener (51) from side panel (23).
2-44
