ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-18. FRONT HOUSING PANEL.
2-18-1. Removal.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c. Remove bolts (9, Figure 2-8), bolts (10), Iockwashers (11), and washers (12).
d.
Remove bolts (13), washers (14), Iockwashers (15), and nuts (16).
e.
Remove front housing panel (17).
2-18-2. Inspection.
Inspect front housing panel (17, Figure 2-8) for dents, cracks, loose paint, and corrosion.
2-18-3. Repair.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
a.
Repair all dents and cracks, and remove all loose paint.
b.
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
c.
Repaint surface in accordance with TM 43–0139. (F) Refer to applicable directives.
2-18-4. Installation.
a.
Install front housing panel (17, Figure 2-8) on generator set with bolts (13), washers (14), lockwashers (15),
and nuts (16).
b. Install bolts (9 and 10), Iockwashers (11), and washers (12).
c.
Connect negative battery cable and close access door.
2-19. FRONT HOUSING SECTION.
2-19-1. Removal.
a.
Shut down generator set.
b. Open left side engine access door and disconnect negative battery cable.
c.
Remove top housing panel, paragraph 2-17-1.
d.
Remove bolts (18, Figure 2-8), Iockwashers (19), and washers (20).
e.
Remove bolts (21), nuts (22), and deflectors (23), (24), and (25).
f.
Remove bolts (2, Figure 2-20), washers (3), and fan guards (4).
g.
Remove front housing panel, paragraph 2-18-1.
h. Remove auxiliary fuel pump, paragraph 2-84-3.
i
.
Remove fuel tank filler neck, paragraph 2-81-1.
j.
Remove fuel transfer pump, paragraph 2-85–3.
2-40
