ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
-
2-19-4.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
r.
s.
t.
u.
v.
w.
x.
2-1 9–5.
a.
b.
c.
d.
Installation.
If removed, install external fuel supply plate (66, Figure 2-8), set rating plate (65), and identification plate (64)
with new rivets (63).
Install door stops (51) on front housing (56) with bolts (49) and nuts (50).
Install holddown plate (48) in bracket (45) with bolt (46) and nuts (47).
Install bracket assembly (45) on air deflector (62) with bolts (42), Iockwashers (43), and washers (44).
Install air deflector (62) on front housing (56) with bolts (57) and nuts (58).
Install bolt (59), Iockwasher (60) and washer (61).
Install channel (41) on front housing (56) and air deflector (62) with bolts (39) and nuts (40).
If replacing fuel tank holddown brackets (37), bond new cotton webbing strips (38) to brackets with adhesive
(Item 1, Appendix C).
Install fuel tank holddown brackets (37) to air deflector (62) with bolts (36).
Install filler neck panel (35) on air deflector (62) with bolts (32), Iockwashers (33), and washers (34).
Install door sills, paragraph 2-19-6.
Install front housing (56) with air deflector (62) on generator set with bolts (52), Iockwashers (53), washers (54)
and nuts (55).
Install front lifting rings (31) and brackets (30) on generator set with bolts (26), Iockwashers (28), washers (29),
and nuts (27).
Adjust bolt (46) in bracket (45) so that holddown plate (48) contacts fuel tank, and tighten nuts (47).
Install fuel tank filler neck, paragraph 2-81-3.
Route electrical leads through air deflector (62) and connect leads, as tagged to fuel level sender and fuel float
module. Remove tags.
Install auxiliary fuel pump, paragraph 2-84-4.
Install fuel transfer pump, paragraph 2-85-4.
Connect fuel supply and fuel return lines at fuel tank fittings (16 and 34, Figure 2-21).
Install radiator, paragraph 2-70-5.
Install front housing panel, paragraph 2-18-4.
Install deflectors (23), (24), and (25) with bolts (21) and nuts (22). Install bolts (18), lockwashers (19), and
washers (20).
Install top housing panel, paragraph 2-17-4.
Connect negative battery cable and close access door.
Removal of Engine Access Door Sills.
Remove bolt (70, Figure 2-8), nut (71), Iockwasher (72), washer (73), front grounding rod bracket (74), and
grounding rods (75) from generator set.
Remove bolts (9, Figure 2-23), washers (10), Iockwashers (11), nuts (12), and plate (13) from left side engine
access door sill (81, Figure 2-8).
Remove bolts (76), nuts (77), Iockwashers (78), and washers (79).
Remove bolts (80), nuts (81), and engine access door sills (82) and (83).
2-43
