ARMY TM 9-6115-639-13
AIR FORCE TO 35C2-3-386-51
MARINE CORPS TM 10155A-13/1
Section III. OPERATION UNDER USUAL CONDITIONS.
2-6. ASSEMBLY AND PREPARATION FOR USE.
WARNING
Use caution when lifting or moving the generator set to prevent injury
to personnel and damage to equipment. Use lifting rings for lifting
device and forklift pockets for forklift only. Do not lift object over
personnel. Failure to observe this warning can result in personal injury
and/or equipment damage.
WARNING
If damaged or defective components are discovered, repair must be
performed before operation can begin. Perform required repairs and
adjustments before proceeding. Do not operate the generator set with
damaged components. Personnel injury can occur if damaged parts are
left unfixed. Failure to observe this warning can result in personal
injury and/or equipment damage.
NOTE
Prior to placing the generator set into service, operating personnel must be
familiar with the location and function of all switches, controls, and
indicators. Refer to Paragraph 2-1, Operators Controls and Indicators, and
Figure 2-1 before continuing with this procedure.
a. Using a 500 pound capacity hoist or similar lifting device, remove the generator set from its shipping
container. Place on a suitable work surface.
b. Remove packing material from generator set.
c. Inspect the generator set for damage incurred during shipping. If the equipment has been damaged,
report the damage on the appropriate form as required.
d.
Check the generator set against the packing slip to ensure that the shipment is complete. Report all
discrepancies in accordance with the instructions of DA PAM 738-750.
2-19
