ARMY TM 9-6115-639-13 AIR FORCE TO 35C2-3-386-51 MARINE CORPS TM 10155A-13/1 4-33.  OUTPUT TERMINALS AND EMI FILTER MAINTENANCE This task covers removal, inspection, and installation. INITIAL SETUP Tools: Equipment Condition: Tool Kit, General Mechanic’s Automotive Generator set shut down (Para. 2-9) (Item 2, App. B, Sect. III) Battery cables disconnected Cable disconnected for SLAVE RECEPTACLE A.    REMOVAL. 1. Unlock generator set enclosure cover latches and lift cover to open. 2. Turn lock (2, Figure 4-24) and open output panel cover (1). 3. Disconnect   load   and   ground   wires   from   load terminals using load wrench (3). 4. Release load wrench (3) lanyard from output box by  removing  screw  (4),  washer  (5),  and  locknut (6).      Remove   lanyard   from   wrench   only   if replacement is required. 5. Tag   and   disconnect   EMI   filter   (9)   electrical connectors.    Remove  EMI  filter  from  load  and ground terminals (10, 11) by removing four nuts (7) and washers (8). 6. Remove load board (15) from generator set  skid base by removing four screws (16), washers (17), and locknuts (18). 7. Remove  load  terminals  (10)  by  removing  nuts (12) and washers (13).  Remove ground terminal (11) by removing nut (14) and washers (13).   Figure 4-24.  Output Terminals / Filter (Sheet 1 of 4) 4-66