ARMY TM 9-6115-639-13
AIR FORCE TO 35C2-3-386-51
MARINE CORPS TM 10155A-13/1
4-34. VOLTAGE RESISTOR MAINTENANCE
This task covers removal, inspection, and installation.
INITIAL SETUP
Tools:
Equipment Condition:
Tool Kit, General Mechanic’s Automotive
Generator set shut down (Para. 2-9)
(Item 2, App. B, Sect. III)
Battery cables disconnected
Cable disconnected for SLAVE RECEPTACLE
A. REMOVAL.
1.
Unlock main access cover latches and lift cover to
open.
2.
Turn lock (2, Figure 4-25) and open output panel
cover (1).
3.
Disconnect electrical wiring from the rear of three
voltage resistors (3).
4.
Remove three voltage resistors (3) from the back
of the output box by removing screws (4),
washers (5), and locknuts (6).
B. INSPECTION.
1.
Inspect voltage resistors for corrosion, evidence
of electrical short, and obvious damage.
2.
Inspect electrical wiring for cuts, crimps, bare
wire, or other damage. Ensure terminal lugs are
securely attached.
3.
Remove and replace any component that is
damaged to the extent that it will effect the safe
operation of the generator set.
Figure 4-25. Voltage Resistors
4-70
