TM
55-2925-236-40
c. The two lengths of sleeving on capacitor (6,
357 F (181 C).
d. The sleeving on capacitor (13) is 1-5/32
in. long.
an acid flux. Do not burn insulation when sol-
e. The sleeving on capacitor (20) is 1-15/32
dering.
in. long.
f. The sleeving on capacitor (27) is 1-1/4 in.
long.
with Federal Specification QQS571.
c. After soldering, clean all joints with dena-
Note. All capacitors are firm components.
tured alcohol (item 7, table 2-3) to remove all
There is no alternate or equivalent part number for
capacitors.
traces of resin and other foreign matter.
3-10. Capacitor Mounting
3-9. Sleeving Replacement
If any capacitors have been removed or re-
All sleeting used on the starter generator is
placed, they must be cemented in their mounting
teflon natural color sleeving, and with the excep-
positions. The material to be used consists of two
tion of the one length specified in step a, all
parts of red epoxy resin (item 9, table 2-3) to
sleeving has an inside diameter between 0.032
one part of tan epoxy reactor (item 10, table
and 0.039 in. The wall thickness on all sleeving
is 0.030 in. Lengths are given in steps a through
through f.
f.
a. Make sure areas to be cemented are free
a. The length of sleeving joining capacitors
from grease, oil, or any contaminant that might
(15, figure 3-1) to terminal post E- has an in-
prevent adhesion.
side diameter between 0.051 and 0.061 in. and is
Stir the epoxy mixture until uniform in
b.
11/2 in. long.
color.
b. The sleeving on the lead of capacitor (15)
to terminal post B + is 2-1/16 in. long.
Note. The pot life of the mixture is 3 hours.
