(2) Installation
(a) Install switch box ground wire terminal (14) on AC GROUND terminal E2 (13) and secure
TM 5-6115-631-14&P
with lockwasher (12) and nut (11).
(b) Install remaining box ground wire terminal (10) on load terminal L0 (8). Install power
cable (white) wire terminals (9) on terminal L0 (8) and secure the three wires with lock-
washer (7) and nut (6).
(c) Position cover (4) on switch box (5) and secure with 16 screws (l), 16 Iockwashers (2)
and 16 flat washers (3).
Figure 4-14. Ground Wire Replacement.
4-26.
Taillight Cable Assembly and Electrical Lead Repair and Replacement. One taillight cable
assembly and one electrical lead connects each taillight to the trailer wiring harness. The taillight
cable assembly and electrical lead are replaced by unplugging four connectors at each end. Repair is
accomplished by replacing defective connectors. To manufacture a replacement cable assembly and
electrical lead, install new connectors on suitable lengths of insulated wire using the procedures
described for repair.
a. Male Connector Replacement. (See figure 4-15.)
(1) Slide shell (1) back on wire lead (2).
4-27
