TM 5-6115-631-14&P
(c) Unscrew nut(13) and internal tooth lockwasher (14) securing indicator light
(15) to cover (4) and slide nut and Iockwasher off wires.
(d) Pull out light and wires through cover (4).
housing
Figure 4-11. Indicator Light and Wire Replacement,
(2) Installation.
(a)
(b)
Feed wires through hole in cover (4) and fit light housing (15) in hole.
Slide nut (13) and Iockwasher (14) over both wires (12), thread onto light housing (14)
on inside of cover (4) and tighten.
Position terminal (9) of each indicator light wire (12) against underside of switch ter-
minal (10). Position terminal of power cable wire (11) against terminal of indicator Mht
wire. Insert screw (6) up through wire terminals and”sw;tch terminal. Install star wa;her
(8) and nut (7) on screw and tighten against switch terminal.
(d) Position cover (4) on switch box (5) and secure with 16 screws (l), 16 Iockwashers (2)
and 16 flat washers (3).
c. Switch to Load Termina/lWire Replacement. (See figure 4-12.) There are three wires
connecting the switch to the load terminals. When attaching wires, refer to the schematic inside the
switch box (figure 4-7 or 4-8, as applicable) and to the identification bands on the wires.
4-23
