TM 5-6115-629-14&P
b. Installation.
(1) Position rear step (11) on trailer frame (6).
(2) Secure rear step (11) to trailer frame (6) with two screws (8), four flat washers (9) and
two nuts (10).
(3) Secure rear step (11) to fender (15) with five screws (12), ten flat washers (13) and five
nuts (14).
(4) Aline two mounting holes in rear step bracket (4) with holes in trailer frame (6) under
taillight (7) and insert two screws (1).
(5) Slide S-hook at chain end of platform anchor (5) onto threaded end of lower screw (1)
inside trailer frame (6).
(6) Install one flat washer (2) and one nut (3) on each screw (1) and tighten.
4-23.
Fender Replacement. (See figure 4-10.) The fenders on the trailer assemblies are
symmetrical, and replacement procedures are the same for all.
a. Removal.
(1)
(2)
(3)
(4)
(5)
(6)
Remove five screws (1, figure 4-10), ten flat washers (2) and five nuts (3) securing
fender (4) to trailer frame (5).
WARNING
There are five sets of hardware securing fender to rear step and seven sets of
hardware securing fender to front step. This hardware should be removed in
sequence from trailer frame outward. In this way, last two screws on front and
rear lower fender edge will support fender until you are out from underneath.
Remove six screws (6), 12 flat washers (7) and six nuts (8) securing fender (4) to front
step (9).
Remove fours screws (10), eight flat washers (11) and four nuts (12) securing fender (4)
to rear step (13).
WARNING
Support fender while removing remaining two screws. When screws are
removed, fender will drop.
Remove one screw (6), two flat washers (7) and one nut (8) securing fender (4) to front
step (9).
Remove one screw (10), two flat washers (11) and one nut (12) securing fender (4) to
rear step (13).
Remove fender (4).
4-23
