TM 5-6115-629-14&P
Figure 4-7. Fire Extinguisher Bracket Replacement.
a. Removal.
(1) Remove four screws (1, figure 4-7), four flat washers (2), and four nuts (3) securing
bracket (4) to step (5).
(2) Remove bracket (4) from step (5).
b. Installation.
(1) Position fire extinguisher bracket (4) on step (5).
(2) Insert four screws (1) down through bracket (4) and through step (5).
(3) Install one washer (2) and one nut (3) on each screw (1). Tighten hardware to secure
bracket (4).
4-21.
Front Steps Replacement. (See figure 4-8.) The roadside and curbside front steps on both
trailers are symmetrical, and replacement procedures are the same except where noted in the steps
below.
a. Removal.
NOTE
When removing roadside front step, omit steps (1) and (2).
(1) Remove fuel can brackets (paragraph 4-18, a).
(2) Remove accessory box (paragraph 4-19, a).
(3) Remove cotter pin (1, figure 4-8) and clevis pin (2) securing handbrake cable (3) to
handbrake lever mechanism (4).
4-19
(4) Remove two screws (5), two flat washers (6) and two nuts (7) securing handbrake bracket
(8) to trailer frame (9).
