Installation. - TM-5-6115-629-14P

Figure 4-8. Front Steps Replacement. - TM-5-6115-629-14P_68

TM-5-6115-629-14P Power Plant AN/MJQ-10A (NSN 6115-00-394-9582) (2) MEP-005A 30 Kw 60 Hz Generator Sets (2) M200A1 2-Wheel 4-Tire Modified Trailer Manual
Page Navigation
52

(6) (7) (8) (9) TM 5-6115-629-14&P Remove two screws (10), two flat washers (11) and two nuts (12) securing handbrake cable bracket (13) to front step (14). NOTE There are two screws, flat washers, and nuts securing handbrake bracket to front step. It is only necessary to remove one set of attaching hardware to remove front step from trailer frame. Remove screw (15), flat washer (16), Iockwasher (17) and nut (18) directly beneath pivot point of handbrake lever (4). Remove seven screws (19), 14 flat washers (20) and seven nuts (21) securing front step (14) to front edge of fender (22). Remove four screws (23, 24 and 25), eight flat washers (26) and four nuts (27) securing front step (14) to edge of trailer frame (9). Remove three screws (28), three flat washers (29) and three nuts (30) securing front step (14) to trailer cross braces (31) and remove front step. b. Installation. (1) (2) (3) (4) (5) (6) (7) NOTE Three different length screws are used to mount the front step. Screws with index numbers (5), (10), (18) and (23) in figure 4-8 are one inch long. Screw with index number (24) is 1-1/4 inch long. Screws with index numbers (15), (22) and (27) are 1.3/4 inch long. Observe lengths and locations when installing hardware. Position front step (14) on cross braces (31) and trailer frame (9). Insert clevis on hand- brake cable (3) through hole in front step (14). Insert four screws (23, 24 and 25) with flat washers (26) through front step (14) and trailer frame (9). Insert three screws (28) with flat washers (29) through front step (14) and trailer cross braces (31). Working under step, install one nut (30) on each screw (28) securing front step (14) to cross braces (31), and install one flat washer (26) and one nut (27) on each screw (23, 24 and 25) securing step to trailer frame (9). Tighten seven sets of hardware. Secure front step (14) to fender (22) with seven screws (19), 14 flat washers (20) and seven nuts (21). Insert screw (15) with flat washer (16) through handbrake bracket (8), front step (14) and cross brace (31). Install Iockwasher (17) and nut (18) on screw from underneath and tighten. Insert two screws (5) with flat washers (6) through handbrake bracket (8) and trailer frame (9). Install one nut (7) on each screw and tighten. 4-21

Privacy Statement
Press Release
Contact