TM 5-6115-629-14&P
(8) Insert two screws (10) through front step (14) and handbrake cable bracket (13). Install
one flat washer (11) and one nut (12) on each screw and tighten.
(9) Position clevis on handbrake cable (3) on handbrake lever mechanism (4). Insert clevis
pin (2) and secure with cotter pin (1).
NOTE
When installing roadside front step, omit steps (10) and (11).
(10) Install accessory box (paragraph 4-19, b).
(11) Install fuel can brackets (paragraph 4-18, b).
4-22.
Rear Steps Replacement. (See figure 4-9.) The roadside and curbside rear steps on both
trailers are symmetrical, and replacement procedures are the same for all.
a. Removal.
(1) Remove two screws (1, figure 4-9), two flat washers (2) and two nuts (3) securing rear
step bracket (4) and platform anchor (5) to trailer frame (6) under taillight (7).
(2) Remove two screws (8), four flat washers (9) and two nuts (10) securing rear step (11) to
trailer frame (6).
(3) Remove five screws (12), ten flat washers (13) and five nuts (14) securing rear step (11)
to fender (15). Remove rear step from trailer.
Figure 4-9. Rear Steps Replacement.
4-22
