TM 5-6115-627-14&P
CHAPTER 5
DIRECT SUPPORT AND GENERAL SUPPORT
MAINTENANCE INSTRUCTIONS
Section l. INTRODUCTION
5-1. General. This chapter contains Direct Support and General Support level maintenance procedures for
components of the M200A1 trailer added when the trailer is used as part of the AN/MJQ-10A power plant. These
components are not covered in the overall trailer maintenance manual. For all other direct and general support
maintenance procedures on the trailer, refer to TM 9-2330-205-14&P. For direct and general support
maintenance procedures on the generator set, refer to TM 5-6115-465-34.
WARNING
Before performing any maintenance that requires climbing on or under trailer, set trailer
handbrakes, chock wheels and lower rear leveling jacks. Injury to personnel could result
from trailer suddenly rolling or tipping.
Section II. MAINTENANCE OF POWER PLANT TRAILER
5-2. Step and Fender Repair. Repair of the front and rear steps and the fenders is limited to straightening,
weldinq and repainting. If required, repaint in accordance with MIL-T-704 and MIL-C-46168.
5-3. Accessory Box Repair. (See figure 5-1.) The accessory boxes are repaired by replacing the latch and
strike assemblies. The boxes themselves may be straightened, welded and repainted. If required, repaint in
accordance with MIL-T-704 and MIL-C-46168. Replace latch and strike assemblies as follows:
a. Grind off or drill out solid rivets (1, figure 5-1) securing latch and strike assembly (2) to accessory box (3).
b. Position new latch and strike assembly (2) on accessory box (3) and secure with solid rivets (1).
c. Touch up with paint as required.
Figure 5-1. Accessory Box Repair.
5-1
