2-13. Testing of Radio Interference Suppression
equipment is not available and interference is in-
Components
dicated, isolate cause by the trial-and-error method
T e s t the capacitors for leaks and shorts on a
of replacing each capacitor in turn until the cause of
interference is located and eliminated.
capacitor tester; replace defective capacitors. If test
Section VIl. MAINTENANCE OF GENERATOR SET
2-14. General Cleaning and Inspection.
(2) Inspect for damage or missing hardware.
a. Clean all metal parts in an approved cleaning
b. Repair.
solvent (e.g., Fed P-D-680).
(1) If canvas cover is torn, repair by sewing.
b. Clean all surfaces and install new gaskets.
(2) Replace missing hardware.
c. Inspect all parts before installing or rein-
(3) Replace canvas cover if damaged or
deteriorated beyond repair.
stallation for cracks, wear, rust, corrosion,
deterioration or any type damage.
d. Inspect all hardware for damaged threads.
a. Removal. Remove the four screws, nuts and
e. Inspect all lines, hoses, and fittings for damage.
clamps and remove the muffler cover (fig. 2-18).
Replace a defective line, hose, or fitting.
2-15. Canvas Cover
screws and nuts (fig. 2-18).
a. Inspection.
(1) Inspect the generator set canvas cover for
rips and tears.
