TB 9-6115-644-13
INSTALLATION
NOTE
Use packing list provided with kit.
1.
Open battery access door and disconnect negative battery cable from right battery and the positive battery cable from the
left battery before doing the following procedures.
2.
Drill holes outside of left side panel using heater-mounting plate (6), Figure 5-1, as a template. Before drilling holes,
look inside housing to verify proper position and clearance of mounting plate. To install the heater mounting plate,
perform the following steps: using the plate as a template, place it 1.75" from the top left access door flange and 2"
across from the door hinge flange to locate the edge of the plate.
NOTE
When mounting the heater (7), to the heater mounting plate (6), the
burner end of the heater shall be higher than the coolant intake end.
3.
Open left side rear door and install heater-mounting plate (6) to left inside panel (5) using screws (4), flatwashers (3),
lock washers (2), and nuts (1). Install heater (7) to heater mounting plate using screws (4), flatwashers (3), lock washers
(2), and nuts (1).
