TM 9-6150-228-13&P
4.18 FUSE HODER AND FUSE.
This task covers:
a.
Test
b.
Removal
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Automotive Tool Kit
Para 2.5 Equipment shut down.
(Item 2, Appendix B).
Para. 4.13 Deadfront panel assembly removed.
Materials/Parts
WARNING
Tags (Item 14, Appendix E).
Sleeving (Item 6, Appendix E)
High voltage is present in this equipment
Solder (Item 7, Appendix E).
during operation. Do not attempt making
Fuse (Item 8, Appendix F, Figure 6).
any repairs without first shutting down all
input power from the power distribution
panel. Failure to observe this warning
Personnel Required
could result in serious injury or death.
One.
REMOVAL
a. Unlock latch (1, Figure 4-10) and remove access door (2) by sliding off hinge.
b. Tag and identify electrical leads.
c. Cut sleeving and unsolder electrical leads.
d. Remove fuse cap (3) and fuse (4).
e. Remove nut (5) from body of fuse holder (6).
f. Remove fuse holder (6) and gasket (7) from bracket (8)
INSTALLATION
a. Install gasket (7) and fuse holder (6) in bracket (8).
b. Install nut (5) on fuse holder (6). Tighten nut.
c. Install sleeving on electrical leads.
d. Solder leads on fuse holder (6).
e. Slide sleeving over solder connections and heat shrink. Remove tags.
4-32
