TM 9-6150-228-13&P
4.17 TERMINAL BLOCKS.
This task covers:
a.
Test
b.
Removal
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Automotive Tool Kit
Reference
(Item 2, Appendix B).
Para. 2-5 Equipment shut down.
Materials/Parts
WARNING
Tags (Item 14, Appendix E).
Lock Washers (Items 4, 7, and 10, Appendix F,
High voltage is present in this equipment
Figure 6).
during operation. Do not attempt making
any repairs without first shutting down all
Personnel Required
input power from the power distribution
panel. Failure to observe this warning
Two
could result in serious injury or death.
REMOVAL
a. Unlock latch (1, Figure 49) and remove access door (2) by sliding off hinge.
b. Tag and identify, five electrical leads (3).
c. Loosen five set screws (5) and disconnect electrical leads (3).
d. Remove six screws (7), lock washers (6), and terminal block (4). Discard lock washers.
e. Remove two screws (10), lock washers (9), and terminal block (8). Discard lock washers.
NOTE
Terminal blocks at each end are removed the same way.
f. Remove screw (11) and lock washer (12), and ground terminal block (13). Discard lock washer.
INSTALLATION
a. Install ground terminal block (13), new lock washer (12), and screw (11). Tighten screw.
b. Install terminal block (8), two new lock washers (9), and screws (10). Tighten screws.
c. Install terminal block (4), six new lock washers (6), and screws (7). Tighten screws.
4-30
