TM 9-6150-226-13
j.
Secure the latches on the feeder/distribution center.
Install
connector caps.
2-11.
OPERATING INSTRUCTIONS ON DECALS AND INSTRUCTION PLATES.
a.
FIGURE 2-11 shows a ground fault test record which is located on the
right side of the control panel on all DISE feeder/distribution centers.
b.
FIGURE 2-1 shows the location of data plates on the control panel of
the M200 equipment, FIGURE 2-2 shows the location of data plates on the control
panel of the M200 A/P equipment,
and FIGURE 2-12 shows the location of the
cable connection data plates.
c.
FIGURE 2-3 shows the location of data plates on the control panel of
the M1OO equipment, FIGURE 2-4 shows the location of data plates on the control
panel of the M1OO A/P equipment,
and FIGURE 2-13 shows the location of the
cable connection data plates.
d.
FIGURE 2-5 shows the location of data plates on the control panel of
the M40 equipment, FIGURE 2-6 shows the location of data plates on the control
panel of the 40 A/P equipment, and FIGURE 2-14 shows the location of the cable
connection data plates.
e.
FIGURE 2-7 shows the location of data plates on the control panel of
the M60 equipment, FIGURE 2-8 shows the location of data plates on the control
panel of the M60 A/P equipment, and FIGURE 2-15 shows the location of the cable
connection data plates.
f.
FIGURE 2-16 shows the warning tag of the DISE and POISE cables.
2-46
