TM 9-6115-730-24
0114
REMOVAL
1. Remove four bolts (Figure 1, Item 1), washers (Figure 1, Item 2), and crankshaft rear seal carrier (Figure 1,
Item 3).
2. Remove gasket (Figure 1, Item 4) from cylinder block.
END OF TASK
INSTALLATION
1. Install gasket over two dowel pins (Figure 1, Item 5).
2. Install crankshaft rear seal carrier (Figure 1, Item 3), four washers (Figure 1, Item 2), and bolts (Figure 1,
Item 1).
3. Install flywheel housing (WP 0113).
4. Install flywheel (WP 0111).
0114-2
