TM 9-6115-730-24
0112
INSTALLATION
1. Clean surface of crankshaft. Lubricate O-ring (Figure 1, Item 6) with engine oil and position on back of
crankshaft rear seal.
NOTE
Leave shipping sleeve on crankshaft rear seal in place. Seal must be installed dry.
2. Position crankshaft rear seal (Figure 1, Item 5) on crankshaft and push into place. This will dislodge the
shipping sleeve.
3. Install six washers (Figure 1, Item 4) and bolts (Figure 1, Item 3).
4. Apply thread locking compound to threads of three locking bolts (Figure 1, Item 1). Install three washers
(Figure 1, Item 2) and locking bolts (Figure 1, Item 1) at bottom of crankshaft rear seal (Figure 1, Item 5).
Torque locking bolts (Figure 1, Item 1) to 79-133 lb-in. (9-15 Nm).
5. Install flywheel (WP 0111).
END OF TASK
END OF WORK PACKAGE
0112-3/4 blank
