TM 9-6115-730-24
0111
REMOVAL
1. Attach suitable lifting device to flywheel (Figure 1, Item 1).
2. Remove eight bolts (Figure 1, Item 2), washers (Figure 1, Item 3), and slide flywheel (Figure 1, Item 1) off
guide pins.
3. If necessary, remove ring gear (Figure 1, Item 4) with a hammer and punch.
END OF TASK
INSTALLATION
WARNING
Wear heat resistant gloves and avoid contacting hot metal surfaces with your hands after flywheel
ring gear has been heated. Wear additional protective clothing as required. Failure to comply can
cause injury to personnel.
1. If removed, heat ring gear to a maximum of 600 degrees F (315 degrees C). Install ring gear (Figure 1,
Item 4) on flywheel (Figure 1, Item 1) with part number toward crankshaft, using a soft hammer.
2. Place flywheel (Figure 1, Item 1) in original position on crankshaft and align arrows on crankshaft and
flywheel.
3. Apply thread locking compound to threads of eight bolts (Figure 1, Item 2). Install eight washers (Figure 1,
Item 3) and bolts (Figure 1, Item 2). Torque bolts (Figure 1, Item 2) evenly to 133-251 lb-ft (260-340 Nm).
0111-2
