TM 9-6115-730-24
0107
ASSEMBLY
1. Install O-ring (Figure 1, Item 37) and plug (Figure 1, Item 36).
2. Install stud (Figure 1, Item 35) and torque to 37-51 lb-ft (50-70 Nm).
3. Install stud (Figure 1, Item 34) and torque to 45-55 lb-ft (61-75 Nm).
4. Install relief valve plunger (Figure 1, Item 33), spring (Figure 1, Item 32), O-ring (Figure 1, Item 31), cover
(Figure 1, Item 30), two washers (Figure 1, Item 29), bolt (Figure 1, Item 28), and stud (Figure 1, Item 27).
5. Install bypass valve (Figure 1, Item 26), spring (Figure 1, Item 25), O-ring (Figure 1, Item 24), cover (Figure 1,
Item 23), two washers (Figure 1, Item 22), bolt (Figure 1, Item 21), and stud (Figure 1, Item 20).
6. Install relief valve plunger (Figure 1, Item 19), spring (Figure 1, Item 18), O-ring (Figure 1, Item 17), cover
(Figure 1, Item 16), two washers (Figure 1, Item 15), and bolts (Figure 1, Item 14).
7. Install spacer (Figure 1, Item 13), retainer (Figure 1, Item 12), retainer spring (Figure 1, Item 11), spring seat
(Figure 1, Item 10), and bolt (Figure 1, Item 9).
END OF TASK
INSTALLATION
1. Apply light coat of engine oil to two O-rings (Figure 1, Item 8), two O-rings (Figure 1, Item 7), and O-ring
(Figure 1, Item 6).
2. Install two O-rings (Figure 1, Item 8) on top of oil filter base (Figure 1, Item 5).
3. Install two O-rings (Figure 1, Item 7) and O-ring (Figure 1, Item 6).
4. Apply thread locking compound to threads of six bolts (Figure 1, Item 1) and four bolts (Figure 1, Item 3).
NOTE
Note which two bottom bolts securing oil filter base to engine block are marked and install in
correct locations.
5. Position oil filter base (Figure 1, Item 5) and install six washers (Figure 1, Item 2) and bolts (Figure 1, Item 1).
6. Install four washers (Figure 1, Item 4) and bolts (Figure 1, Item 3).
7. Install oil filter (WP 0079).
END OF TASK
END OF WORK PACKAGE
0107-4
