TM 9-6115-730-24
0108
REMOVAL
1. Remove two bolts (Figure 1, Item 1), one stud (Figure 1, Item 2), and three washers (Figure 1, Item 3).
2. Remove elbow (Figure 1, Item 4), coupling (Figure 1, Item 5), two O-rings (Figure 1, Item 6), and O-ring
(Figure 1, Item 7).
3. Remove three bolts (Figure 1, Item 8) and washers (Figure 1, Item 9).
4. Remove three bolts (Figure 1, Item 10), washers (Figure 1, Item 11), oil cooler (Figure 1, Item 12), and three
O-rings (Figure 1, Item 13).
5. Loosen two hose clamps (Figure 1, Item 14) and remove bonnet (Figure 1, Item 15), hose (Figure 1, Item 16)
from elbow (Figure 1, Item 17).
6. If necessary, remove two screws (Figure 1, Item 18), washers (Figure 1, Item 19), elbow (Figure 1, Item 17),
and gasket (Figure 1, Item 20).
7. If necessary, remove three plugs (Figure 1, Item 21) from elbow (Figure 1, Item 17).
8. If necessary, remove plug (Figure 1, Item 22) from bonnet (Figure 1, Item 15).
9. If necessary, remove plug (Figure 1, Item 23) and O-ring (Figure 1, Item 24) from elbow (Figure 1, Item 17).
END OF TASK
CLEANING
1. Clean cooler core with brush.
2. Clean tube bundles with rod of suitable diameter.
3. Inspect oil cooler for cracks or leaks.
END OF TASK
INSTALLATION
1. If necessary, install plug (Figure 1, Item 23) and O-ring (Figure 1, Item 24) to elbow (Figure 1, Item 17).
2. If necessary, install plug (Figure 1, Item 22) to bonnet (Figure 1, Item 15).
3. If necessary, install three plugs (Figure 1, Item 21) to elbow (Figure 1, Item 17).
0108-2
