TM 9-6115-730-24
0098
CAUTION
All fittings and openings must be capped or plugged immediately after opening to prevent
contamination of the fuel system.
NOTE
Cut tiedown straps as required during removal. Install tiedown straps as required during
installation. Table 1 identifies removal and installation steps for engine sensors.
REMOVAL
Table 1. WP 0098 Guide.
FIGURE 1
REMOVAL
INSTALLATION
RELATED
NAME
ITEM
STEPS
STEPS
WP
Oil pressure sensor
1
1 and 2
34 and 35
Fuel temperature sensor
4
3 and 4
32 and 33
Fuel pressure sensor
5
5 thru 7
29 thru 31
Magnetic speed pickup
9
8 and 9
25 thru 28
Coolant temperature sensor
10
10 thru 13
21 thru 24
Intake manifold air
16
14 thru 16
18 thru 20
temperature sensor
Turbo outlet pressure sensor
17
17 and 18
16 and 17
Low coolant sensor
18
19 and 20
14 and 15
Turbo inlet pressure sensor
19
21 and 22
12 and 13
Atmospheric temperature
20
23 thru 25
9 thru 11
sensor
Camshaft speed/timing
23
26 and 27
7 and 8
sensor (top)
Crankshaft speed/timing
27
29 and 30
1 thru 6
sensor (bottom)
1. Tag and disconnect engine harness connector ENG-P201 from oil pressure sensor (Figure 1, Sheet 1,
Item 1),
2. Remove engine oil pressure sensor (Figure 1, Sheet 1, Item 1), seal (Figure 1, Sheet 1, Item 2) and elbow
(Figure 1, Sheet 1, Item 3).
3. Tag and engine harness connector ENG-P105 from fuel temperature sensor (Figure 1, Sheet 1, Item 4).
4. Remove fuel temperature sensor (Figure 1, Sheet 1, Item 4) with O-ring.
5. Drain sufficient fuel from system so fuel does not spill during removal of sensor.
6. Tag and disconnect engine harness connector ENG-P202 from fuel pressure sensor (Figure 1, Sheet 1,
Item 5).
