TM 9-6115-730-24
0098
REMOVAL - Continued
15. Tag and disconnect engine harness connector ENG-P103 from intake manifold air temperature sensor
(Figure 1, Sheet 2, Item 16).
16. Remove intake manifold air temperature sensor (Figure 1, Sheet 2, Item 16) with O-ring from engine.
17. Tag and disconnect engine harness connector ENG-P200 from turbo outlet pressure sensor (Figure 1, Sheet
2, Item 17).
18. Remove turbo outlet pressure sensor (Figure 1, Sheet 2, Item 17) with O-ring.
19. Tag and disconnect ECM to EMCP harness connector ENG-P16 from low coolant sensor (Figure 1, Sheet 2,
Item 18).
20. Remove low coolant sensor (Figure 1, Sheet 2, Item 18) from coolant surge tank.
21. Tag and disconnect ECM to EMCP harness connector ENG-P8 from turbo inlet pressure sensor (Figure 1,
Sheet 2, Item 19).
22. Remove turbo inlet pressure sensor (Figure 1, Sheet 2, Item 19) with O-ring.
23. Remove bolt (Figure 1, Sheet 2, Item 22) and clamp (Figure 1, Sheet 2, Item 21).
24. Tag and disconnect engine harness connector ENG-P203 from atmospheric pressure sensor (Figure 1,
Sheet 2, Item 20).
25. Remove atmospheric pressure sensor (Figure 1, Sheet 2, Item 20) with O-ring.
26. Tag and disconnect engine harness connector ENG-P402 from camshaft timing sensor (Figure 1, Sheet 3,
Item 23).
27. Remove camshaft timing sensor (Figure 1, Sheet 3, Item 23) with O-ring.
28. Remove bolt (Figure 1, Sheet 3, Item 25) and clamp (Figure 1, Sheet 3, Item 26).
29. Tag and disconnect engine harness connector ENG-P401 from crankshaft timing sensor (Figure 1, Sheet 3,
Item 27).
30. Remove crankshaft timing sensor (Figure 1, Sheet 3, Item 27) with O-ring.
END OF TASK
INSTALLATION
1. Install crankshaft timing sensor (Figure 1, Sheet 3, Item 27) with O-ring.
2. Remove tag and connect engine harness connector ENG-P401 to crankshaft timing sensor (Figure 1,
Sheet 3, Item 27).
3. Install bolt (Figure 1, Sheet 3, Item 25) and clamp (Figure 1, Sheet 3, Item 26).
4. Set cylinder no. 1 at top center of intake or exhaust stroke (WP 0013, SYMPTOM 8).
0098-6
