TM 9-6115-730-24
0099
INSTALLATION
1. Apply light coat of grease to lips of seal (Figure 1, Item 9). Apply approximately 1/4 ounce (5 grams) of grease
to each bearing (Figure 1, Item 8) and (Figure 1, Item 5). Apply approximately 1 ounce (30 grams) of grease
to cavity of hub (Figure 1, Item 6).
2. Apply sealing compound to threads of bolt (Figure 1, Item 1).
3. Install pulley (Figure 1, Item 11) on spindle (Figure 1, Item 12) and install spacer (Figure 1, Item 10), seal
(Figure 1, Item 9), bearing (Figure 1, Item 8), spacer (Figure 1, Item 7), and hub (Figure 1, Item 6).
4. Install pin (Figure 1, Item 4) in plate (Figure 1, Item 3) and install bearing (Figure 1, Item 5), plate (Figure 1,
Item 3), washer (Figure 1, Item 2), and bolt (Figure 1, Item 1).
5. Using two bolts from fan installation (WP 0066), align holes in hub (Figure 1, Item 6) with holes in pulley
(Figure 1, Item 11). Torque bolt (Figure 1, Item 1) to 74-95 lb-ft (100-130 Nm). Remove two fan bolts.
6. Install engine fan (WP 0066).
END OF TASK
END OF WORK PACKAGE
0099-3/4 blank
