TM 9-6115-730-24
0068
REMOVAL - Continued
11. At top of engine, remove eight hose clamps (Figure 1, Sheet 2, Item 18), two bellows (Figure 1, Sheet 2,
Item 19), and manifold in tube (Figure 1, Sheet 2, Item 20).
12. Remove two hose clamps (Figure 1, Sheet 2, Item 21), coolant hose (Figure 1, Sheet 2, Item 22), two hose
clamps (Figure 1, Sheet 2, Item 23), upper radiator hose (Figure 1, Sheet 2, Item 24), and elbow (Figure 1,
Sheet 2, Item 25).
13. Remove two screws (Figure 1, Sheet 2, Item 26), lockwashers (Figure 1, Sheet 2, Item 27), and washers
(Figure 1, Sheet 2, Item 28).
14. Remove two screws (Figure 1, Sheet 2, Item 29), lockwashers (Figure 1, Sheet 2, Item 30), nuts (Figure 1,
Sheet 2, Item 31), and two upper radiator mounting tie rods (Figure 1, Sheet 2, Item 32) from radiator
(Figure 1, Sheet 1, Item 6) and upper radiator support mounting bracket (Figure 1, Sheet 2, Item 33).
WARNING
Radiator weighs more than 140 pounds (64 kg) and requires a two-person lift. Lifting radiator can
cause back strain. Ensure proper lifting techniques are used when lifting radiator. Failure to
comply can cause injury to personnel.
15. Under radiator (Figure 1, Sheet 1, Item 6), remove two screws (Figure 1, Sheet 2, Item 34), lockwashers
(Figure 1, Sheet 2, Item 35), and washers (Figure 1, Sheet 2, Item 36), and remove radiator (Figure 1, Sheet 1,
Item 6) out of housing through left front door assembly (latch).
16. Remove four screws (Figure 1, Sheet 2, Item 37), lockwashers (Figure 1, Sheet 2, Item 38), washers (Figure 1,
Sheet 2, Item 39), radiator air block plate (Figure 1, Sheet 2, Item 40) and foam (Figure 1, Sheet 2, Item 41)
from upper right side of radiator (Figure 1, Sheet 1, Item 6). Repeat for left side of radiator (Figure 1, Sheet 1,
Item 6).
END OF TASK
REPAIR OR REPLACEMENT
1. For repair of the radiator, refer to procedures in TM 750-254, Cooling Systems: Tactical Vehicles.
2. Inspect foam (Figure 1, Sheet 2, Item 41) and repair or replace, as required.
END OF TASK
0068-5
