TM 9-6115-730-24
0067
INSTALLATION - Continued
9. At top of surge tank, connect hose (Figure 1, Sheet 2, Item 28) and hose (Figure 1, Sheet 2, Item 27), and
install two hose clamps (Figure 1, Sheet 2, Item 26).
10. At radiator filler neck, install hose (Figure 1, Sheet 3, Item 25) and two hose clamps (Figure 1, Sheet 3,
Item 24).
11. At rear of engine, install reducer fitting (Figure 1, Sheet 3, Item 23), drain valve (Figure 1, Sheet 3, Item 1),
hose (Figure 1, Sheet 3, Item 22), and two hose clamps (Figure 1, Sheet 3, Item 21).
12. At bottom of radiator, install 90 degree elbow (Figure 1, Sheet 3, Item 20), nipple (Figure 1, Sheet 3, Item 19),
drain valve (Figure 1, Sheet 3, Item 2), 90 degree elbow (Figure 1, Sheet 3, Item 18), and fitting (Figure 1,
Sheet 3, Item 17).
13. Install hose (Figure 1, Sheet 1, Item 16) and loop clamp (Figure 1, Sheet 4, Item 15) to bottom of water
separator filter.
14. Install hose (Figure 1, Sheet 3, Item 13) and three hose clamps (Figure 1, Sheet 4, Item 12) on tee fitting
(Figure 1, Sheet 4, Item 14).
15. At lower rear of radiator, install loop clamp (Figure 1, Sheet 4, Item 11), washer (Figure 1, Sheet 4, Item 10),
screw (Figure 1, Sheet 4, Item 9), and locknut (Figure 1, Sheet 4, Item 8).
16. Connect hose (Figure 1, Sheet 3, Item 6) to tee fitting (Figure 1, Sheet 3, Item 7) and to coolant recovery
system, and install two hose clamps (Figure 1, Sheet 3, Item 5).
17. Install hose (Figure 1, Sheet 3, Item 4) to coolant recovery system and radiator filler neck and install two hose
clamps (Figure 1, Sheet 3, Item 3).
18. Close drain valve (Figure 1, Sheet 3, Item 2) on front right side bottom of engine and close drain valve
(Figure 1, Sheet 3, Item 1) on right rear side of engine.
NOTE
Coolant system capacity is 42 quarts (39.7 liters).
19. Refill cooling system with coolant.
20. Install side access cover (WP 0029).
21. Close right rear doors, right front doors, left rear doors, and left front door.
END OF TASK
END OF WORK PACKAGE
0067-8
