TM 9-6115-730-24
0068
INSTALLATION - Continued
13. Install sill on upper edge of left front door assembly (latch) opening.
14. Close left front door and right front doors.
15. Install fan guards, shrouds, and upper and lower shroud plates (WP 0066).
16. Install engine generator compartment ceiling assembly (WP 0032).
17. Install exhaust system (WP 0069).
18. Install rear roof section housing assembly (WP 0031).
19. Install front roof section housing assembly (WP 0030).
NOTE
Coolant system capacity is 38 quarts (34.5 liters).
20. Close drain valves (Figure 1, Sheet 1, Item 1) and (Figure 1, Sheet 1, Item 2). Refill cooling system with
coolant. Add coolant as required.
21. Set Battery Disconnect Switch to ON and DEAD CRANK SWITCH to ON. On EMCP set ENGINE CONTROL
switch to START.
22. With engine running, check for leaks.
END OF TASK
FLUSHING
For flushing of the cooling system, refer to procedures in TM 750-254, Cooling Systems: Tactical Vehicles.
END OF TASK
END OF WORK PACKAGE
0068-7/8 blank
