TM 9-6115-730-24
0055
REMOVAL
NOTE
Table 1 identifies removal and installation steps for maintenance significant components of the
electrical installation. Cut tiedown straps as required.
Table 1. WP 0055 Guide.
FIGURE 1
REMOVAL
INSTALLATION
NAME
ITEM
STEPS
STEPS
DEAD CRANK SWITCH
1
1 thru 3
13
CATSW1 (RESET SW FUEL)
15
1, 2 and 6
10
CATSW2 (RESET SW OIL)
16
1, 2 and 6
10
Slave relay SRY
19
1, 2 and 7
9
Starter motor magnetic switch
23
1, 2 and 8
8
(SMMS) relay
Circuit breaker CB2
47
1, 2 and 13
3
Circuit breaker CB4
46
1, 2 and 13
3
Circuit breaker CB5
45
1, 2 and 13
3
Ammeter shunt R4
37
1, 2 and 11
5
Diode D1
39
1, 2 and 12
4
Fuses F1, F2, and F3
55
1, 2 and 15
1
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open right rear doors and left rear doors.
3. To remove DEAD CRANK SWITCH (Figure 1, Sheet 1, Item 1), tag and disconnect wires from switch, remove
nut (Figure 1, Sheet 1, Item 2), lockwasher (Figure 1, Sheet 1, Item 3), and switch.
