TM 9-6115-729-24
0106
REMOVAL
1. Remove two screws (Figure 1, Item 1), washers (Figure 1, Item 2), tube (Figure 1, Item 3), gasket (Figure 1,
Item 4), and seal (Figure 1, Item 5).
2. Disconnect tube (Figure 1, Item 6) and remove two O-rings (Figure 1, Item 7) and connector (Figure 1,
Item 8) from turbocharger (Figure 1, Item 9).
3. Loosen two hose clamps (Figure 1, Item 10) and remove hose (Figure 1, Item 11).
4. Remove four locknuts (Figure 1, Item 12), turbocharger (Figure 1, Item 9), and gasket (Figure 1, Item 13) from
four studs (Figure 1, item 14) of engine block.
END OF TASK
INSTALLATION
1. Apply antiseize compound to threads of four studs (Figure 1, Item 14). Install gasket (Figure 1, Item 13),
turbocharger (Figure 1, Item 9), and four locknuts (Figure 1, Item 12). Torque four locknuts to 36-44 lb-ft
(49-60 Nm).
2. Install hose (Figure 1, Item 11) and tighten two hose clamps (Figure 1, Item 10).
3. Install two O-rings (Figure 1, Item 7) and connector (Figure 1, Item 8) on turbocharger (Figure 1, Item 9), and
connect tube (Figure 1, Item 6).
4. Install seal (Figure 1, Item 5), gasket (Figure 1, Item 4), tube (Figure 1, Item 3), two washers (Figure 1, Item 2),
and screws (Figure 1, Item 1). Torque screws (Figure 1, Item 1) to 15-25 lb-ft (20-34 Nm).
0106-2