TM 9-6115-729-24
0105
REMOVAL - Continued
3. Use slide hammer puller to remove front seal (Figure 1, Item 2).
END OF TASK
INSTALLATION
CAUTION
Crankshaft flange and adjacent front housing must be thoroughly clean before installing a new
front seal or seal will be damaged.
NOTE
Replacement crankshaft front seal is supplied with a shipping sleeve. Do not remove shipping
sleeve until seal is installed.
Crankshaft front seal is designed to be installed dry.
1. Position crankshaft front seal (Figure 1, Item 2) over crankshaft.
2. Use old front seal to protect new front seal and install. Remove old front seal.
3. Install retaining plate (Figure 1, Item 3), four washers (Figure 1, Item 4), and screws (Figure 1, Item 5).
NOTE
Front seal is properly seated when recessed into front housing 0.08-0.12 in. (0.20-0.30 cm).
4. Measure distance from surface of crankshaft front seal (Figure 1, Item 2) to surface of front housing. Tighten
four screws (Figure 1, Item 5) until seal is properly seated.
5. Remove four screws (Figure 1, Item 5), washers (Figure 1, Item 4), and retaining plate (Figure 1, Item 3).
6. Remove shipping sleeve from crankshaft front seal (Figure 1, Item 2).
7. Apply light coat of liquid cleaner to inside diameter of excluder (Figure 1, Item 1).
8. Install excluder (Figure 1, Item 1) on crankshaft pulley (Figure 1, Item 6) approximately 1/4 inch (0.6 cm).
9. Continue installation of crankshaft pulley and damper (WP 0104).
0105-2
