TM 9-6115-729-24
0062
WARNING
Diesel fuel is flammable and toxic to eyes, skin, and respiratory tract. Skin and eye protection are
required when working in contact with diesel fuel. Avoid repeated or prolonged contact. Provide
adequate ventilation. Failure to comply can cause injury or death to personnel.
CAUTION
All fittings and openings must be capped or plugged immediately after opening to prevent
contamination of the fuel system.
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Remove four screws (Figure 1, item 1), washers (Figure 1, item 2), nuts (Figure 1,item 3), two hold down
assemblies (Figure 1, item 4), and remove fuel tank (Figure 1, item 5).
END OF TASK
REPAIR
Repair damage to fuel tank with adhesive repair kit, following directions provided with the kit.
END OF TASK
INSTALLATION
1. Install fuel tank (Figure 1, item 5), two hold down assemblies (Figure 1, item 4), four screws (Figure 1, item 1),
washers (Figure 1, item 2), and nuts (Figure 1, item 3).
2. Install fuel drain valve and piping (WP 0056).
3. Install fuel hoses and fittings (WP 0056).
4. Connect fuel filler inlet (WP 0056).
5. Install fuel level sensor (WP 0061).
6. Install fuel pickup tube (WP 0057).
7. Install fuel level switch assembly (WP 0055).
8. Install engine (WP 0098).
9. Install auxiliary fuel pump (WP 0058).
0062-2
