TM 9-6115-729-24
0061
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left rear doors.
NOTE
Cut tiedown straps as required.
3. Tag and disconnect wires from fuel level sender (Figure 1, Sheet 1, Item 1).
CAUTION
Note and mark orientation of sender assembly to ensure proper orientation of float when installed,
or incorrect fuel level indications will result.
4. Remove five screws (Figure 1, Sheet 1, Item 2), lockwashers (Figure 1, Sheet 1, Item 3), washers (Figure 1,
Sheet 1, Item 4), fuel level sender assembly (Figure 1, Sheet 1, Item 1), and gasket (Figure 1, Sheet 1,
Item 5).
END OF TASK
TEST AND INSPECTION
1. Set up fuel level sender (Figure 1, Sheet 1, Item 1), fuel level indicator (WP 0038, Item 65), and DC power
supply as shown. Adjust power supply for 24-28 Vdc.
2. Hold fuel level sender (Figure 1, Sheet 1, Item 1) in vertical position with armature (Figure 1, Sheet 1, Item 6)
hanging down. Fuel level indicator should read "E" +/- 1/8 inch.
3. Raise armature (Figure 1, Sheet 1, Item 6) to full up position. Fuel level indicator should read "F" +/- 1/8 inch.
4. Check resistance with armature (Figure 1, Sheet 1, Item 6) full down and full up for correct readings.
5. If fuel level indicator readings or resistance measurements are incorrect, replace fuel level sender (Figure 1,
Sheet 1, Item 1).
6. Bend armature (Figure 1, Sheet 1, Item 6) as required to achieve dimensions shown.
0061-2
