TM 9-6115-729-24
0060
WATER SEPARATOR FILTER REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
NOTE
Cut tiedown straps as required.
2. Open left front doors.
3. Remove clamp (Figure 1, Item 4) and disconnect hose (Figure 1, Item 5) from drain port on bottom of water
separator filter bowl (Figure 1, Item 3).
4. Disconnect hose (Figure 1, Item 9) and hose (Figure 1, Item 10) from water separator filter assembly (Figure
1, Item 7).
5. Remove two nuts (Figure 1, Item 11), four washers (Figure 1, Item 12), two screws (Figure 1, Item 13), and
water separator filter assembly (Figure 1, Item 7).
6. Remove two nuts (Figure 1, Item 14), washers (Figure 1, Item 15), screw (Figure 1, Item 16), and bracket
(Figure 1, Item 17).
7. Remove hose clamp (Figure 1, Item 18), swivel (Figure 1, Item 19), clamp (Figure 1, Item 20), and elbow
(Figure 1, Item 21), from hose (Figure 1, Item 22).
8. If necessary, remove two elbows (Figure 1, Item 23).
END OF TASK
WATER SEPARATOR FILTER INSTALLATION
NOTE
Install tiedown straps as required.
1. Apply sealing compound to male threads and install two elbows (Figure 1, Item 23) on water separator filter
assembly (Figure 1, Item 7).
2. Install elbow (Figure 1, Item 21) on hose (Figure 1, Item 22), with swivel (Figure 1, Item 19), and clamp
(Figure 1, Item 18).
3. Install bracket (Figure 1, Item 17), two screws (Figure 1, Item 16), washers (Figure 1, Item 15), and nuts
(Figure 1, Item 14).
4. Install water separator filter assembly (Figure 1, Item 7) on bracket (Figure 1, Item 17), and secure with two
screws (Figure 1, Item 13), four washers (Figure 1, Item 12), and two nuts (Figure 1, Item 11).
0060-4
