TM 9-6115-729-24
0063
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open right rear doors.
3. Place container under coolant recovery system bottle (Figure 1, Item 1).
4. Remove two hose clamps (Figure 1, Item 2) securing hoses (Figure 1, Item 3) and (Figure 1, Item 4) to coolant
recovery system bottle (Figure 1, Item 1) and disconnect two hoses.
5. Drain coolant into suitable container until coolant recovery system is empty. Retain coolant for refilling cooling
system.
6. Remove two screws (Figure 1, Item 5), washers (Figure 1, Item 6), lockwashers (Figure 1, Item 7), and coolant
recovery system bottle (Figure 1, Item 1).
END OF TASK
INSTALLATION
1. Install coolant recovery system bottle (Figure 1, Item 1), two lockwashers (Figure 1, Item 7), washers (Figure
1, Item 6), and screws (Figure 1, Item 5).
2. Connect two hoses (Figure 1, Item 3) and (Figure 1, Item 4) to coolant recovery system bottle (Figure 1, Item
1) and secure with two hose clamps (Figure 1, Item 2).
3. Pour coolant into coolant recovery system bottle (Figure 1, Item 1). If necessary, add coolant so level is
between HOT and COLD marks on bottle.
4. Close right rear doors.
0063-2
