TM 9-6115-729-24
0051
REMOVAL - Continued
3. Open left rear doors.
NOTE
Each current transformer has a cable running through it. These cables must be disconnected at
one end in order to remove the current transformer.
Cut tiedown straps as required.
4. Identify the cables running through three current transformers (Figure 1, Sheet 1, Item 1) adjacent to main
load contactor K1 and disconnect one end of each cable.
5. Remove twelve screws (Figure 1, Sheet 1, Item 2), lockwashers (Figure 1, Sheet 1, Item 3), washers (Figure
1, Sheet 1, Item 4), and three current transformers (Figure 1, Sheet 1, Item 1).
6. If necessary, remove two screws (Figure 1, Sheet 1, Item 5), lockwashers (Figure 1, Sheet 1, Item 6),
washers (Figure 1, Sheet 1, Item 7), and current transformer bracket (Figure 1, Sheet 1, Item 8).
7. Identify the cables running through three current transformers (Figure 1, Sheet 2, Item 9) above the generator
and disconnect one end of each cable.
8. Remove twelve screws (Figure 1, Sheet 2, Item 10), lockwashers (Figure 1, Sheet 2, Item 11), washers
(Figure 1, Sheet 2, Item 12), locknuts (Figure 1, Sheet 2, Item 13), and three current transformers (Figure 1,
Sheet 2, Item 9).
9. Identify the cable running through current transformer (Figure 1, Sheet 2, Item 14) above two power
transformers and disconnect one end of cable.
10. Remove four screws (Figure 1, Sheet 2, Item 15), washers (Figure 1, Sheet 2, Item 16), lockwashers (Figure 1,
Sheet 2, Item 17), and current transformer (Figure 1, Sheet 2, Item 14).
END OF TASK
TEST
1. Using multimeter, measure continuity between the two leads for each transformer. Ensure that continuity is
measured and that there are no opens.
END OF TASK
INSTALLATION
1. Put one end of cable through current transformer (Figure 1, Sheet 2, Item 14) to be installed above two power
transformers, remove tag, and connect end of cable.
2. Install current transformer (Figure 1, Sheet 2, Item 14), four washers (Figure 1, Sheet 2, Item 16), lockwashers
(Figure 1, Sheet 2, Item 17), and screws (Figure 1, Sheet 2, Item 15). Connect wires to current transformer
(Figure 1, Sheet 2, Item 14).
0051-2
